Cakewalk - SONAR Documentation - Euphonix EuCon control surface support

External devices ► Euphonix EuCon control surface support

Euphonix EuCon control surface support

SONAR supports the Euphonix EuCon protocol, which allows SONAR to be controlled by Euphonix surfaces such as the MC and CM408 series.

To enable EuCon support in SONAR

1.

Follow your Euphonix surface’s instructions for physically connecting the Euphonix surface to your computer and configure the Euphonix software.

2.

In SONAR, go to Edit > Preferences > MIDI - Control Surfaces.

3.

Click the Add Controller/Surface button , which opens the Controller/Surface Settings dialog box.

4.

In the Controller/Surface field of the Controller/Surface Settings dialog box, select EuCon Controller.

5.

Click OK to close the Controller/Surface Settings dialog box.

Note: It is not necessary to select any input or output ports.

6.

In the Preferences dialog box (MIDI - Control Surfaces page), make sure that the WAI Display check boxes and the ACT Indicators check boxes are enabled, and click OK.

For more information about using the EuCon Controller surface, see the separate EuCon Controller online Help (open the EuCon Controller plug-in and press F1).

See also:

To connect a controller/surface to SONAR

	Note: It is not necessary to select any input or output ports.

Tip - Searching Documentation

Tip: To search for a specific topic, type your search query in the Search Cakewalk.com field at the top right of this page.

When the search results appear, click which product's documentation you would like to search to filter the search results further.

Note - Using Offline Help

Note: If you prefer to always use offline Help, go to Edit > Preferences > File > Advanced in your Cakewalk software and select Always Use Offline Help.

If you are not connected to the internet, your Cakewalk software will default to showing offline help until an internet connection becomes available.