The information in this article applies to:

• SONAR REAC Recording System

If an audio device does not appear in the REAC Panel Output Monitor ASIO Device list, ensure that the SPS/FA-66 is connected, powered on and is set to the correct sample rate. If the sample rate on the SPS/FA-66 needs to be changed, follow the steps below:

1. Close SONAR
2. Turn the SPS/FA-66 off. You do not need to disconnect it from the PC.
3. Change the sample rate on the SPS/FA-66.
4. Turn the SPS/FA-66 on.
5. Start SONAR
6. Open a project
   
   You do not need to restart your computer in order for
   this change to take effect.