Cakewalk - SONAR X2 Documentation

Punch module

The Punch module lets you control auto-punch settings.

To show/hide the Punch module

Right-click the Control Bar and select Punch module.

Figure 163. The Punch module.

A. Auto-Punch On/Off B. Set Punch Time to Select C. Punch In Time D. Punch Out Time

The Punch module contains the following controls:

Auto-Punch on/off . Enable/disable punch recording. Toggles punch recording on/off.

Set Punch Time to Selection . Set the Punch In time to the start (From) time of the selection, and the Punch Out time to the end (Thru) time of the selection.

Punch In Time. The current Punch In time. Click to modify.

Punch Out Time. The current Punch Out time. Click to modify.

Tip: If a numeric time field has focus, you can press G to access a list of marker positions.

See:

Punch recording

See also:

Tools module

Snap module

Transport module

Loop module

Mix module

ACT module

Screenset module

Performance module

Select module

Markers module

Event Inspector module

Sync Module

	Tip: If a numeric time field has focus, you can press G to access a list of marker positions.

Tip - Searching Documentation

Tip: To search for a specific topic, type your search query in the Search Cakewalk.com field at the top right of this page.

When the search results appear, click which product's documentation you would like to search to filter the search results further.

Note - Using Offline Help

Note: If you prefer to always use offline Help, go to Edit > Preferences > File > Advanced in your Cakewalk software and select Always Use Offline Help.

If you are not connected to the internet, your Cakewalk software will default to showing offline help until an internet connection becomes available.